accessories_explanations

accessories explanations

Explanations of unclear material, typography corrections, drawing corrections, and elaboration on what may have been left out goes here.

There is a mistake in the table of gears on page 123. The 48 tooth gear requires rotating the handle on the dividing head 20 holes in the 24 hole circle. Using 21 holes will result in a 46 1/2 tooth gear. -- John Schwytzer

There is a problem with boring the tumbler plate, page 133. The distance from the center of the bore to the end of the stem is approximately 3 5/8". To bore it your lathe will need a swing of over 7 1/4". -- John Schwytzer